Fluke 2052 Advanced Wire Tracer - CAT IV 600V
The Fluke 2052 Advanced Wire Tracer provides the highest safety protection rating available (CAT IV 600 V), to accurately troubleshoot energised and de-energised wires in all residential, commercial and industrial environments. Designed to ensure protection from dangerous levels (up to 8kV) of transient overvoltage that can occur in industrial plants, factories and hospitals etc, where equipment can not be turned off.
Using the wire tracer a technician can find breaks, opens and shorts. Using different modes and functions allows troubleshooting of a wide spectrum of electrical wiring and circuitry issue you may encounter.
Four Receiver Tracing Modes
The 2052 receiver detects the signal in wires and cables using two methods: Passive tracing without a transmitter for non-contact voltage detection; and active tracing using the transmitter.
- Quick Scan: mode for quick signal identification;
- Precision: mode for more precise detection of a wire;
- Breaker: mode for easy breaker and fuse identification based on the highest recorded signal detected;
- Non-Contact Voltage Detection: mode to trace energised wires without the use of the transmitter.
The receiver has eight sensitivity levels allowing more flexibility and accuracy during tracing.
Three Transmitter Power Modes
The 2000T transmitter works on energised and de-energised circuits up to CAT IV 600 V. It features high, low and loop modes:
- High: mode for normal energised and de-energised circuits;
- Low: mode for precision tracing with a low signal to reduce coupling to nearby wires and metal objects;
- Loop: mode for closed loop de-energised circuits.
The transmitter will automatically sense whether the system is energised and either selects a 6 kHz or 33 kHz frequency.
Complete Kit
The Fluke 2052 comes with everything required to be able to start tracing wires and circuits. Included in the kit is the following:
- 2052R Receiver;
- 2000T Transmitter;
- i400 AC Current Clamp (used with 'loop mode');
- Test Leads;
- Test Probes;
- Blade and round outlet adapters;
- Alligator clips;
- Batteries;
- Carry Case.
Specification
- Measurement Category: CAT IV 600 V
- Operating Voltage/ Current: 0-600 V AC/DC, 10A
- Response time: Sensor Tip 500ms, NCV 500ms, Battery monitoring 5s
- Range:
- Tip sensor energised: up to 6.1m, Pin pointing ~ 5cm
- Tip sensor de-energised: up to 4.5m, Pin pointing ~ 5cm
- NCV (40 Hz to 400 Hz): Max sensitivity 90 V up to 2m, Min sensitivity 600 V up to 1cm
- i400 Current Clamp: 400A
- IP Rating: IP 40
- Power supply: Rx 4 x AA (~ 16h), Tx 8 x AA (~ 18-25h).
See datasheet for more details.
